 dis101.jpg |
Okay, I have high lighted a few of the items that I had a problem remembering on the Charger. Here the little green helper arrows point to the undercoating line and the side marker retaining bracket. The bracket is a silver cad finish and the edge of the undercoating is not a sharp line.
|
 dis102.jpg |
A couple of arrows here pointing out the body plug that will need to go in the new floor. I use a holesaw for there then trim the edges with a moto tool. The other arrow is showing where the door interior paint is laid on. It looks like there is a small mask in the center of the door then the color is sprayed on.
.
|
 dis103.jpg |
Again a body plug goes here so don't forget to drill the hole and also notice where the lower body paint is applied.
|
 dis104.jpg |
Two more arrows here, one is pointing to the bolt in the bracket for the dual exhaust and the second one points to a bolt that goes through the floor and had a clip nut on the other side. This bolt is on both sides of the car and I do not know what it does but it is on every B Body I have seen and if anybody knows what they are for please e-mail me and let us all know the purpose.
|
 dis105.jpg |
Here is close shot of the D/S fender well and the clips that keep the brake lines, e-brake cable and speedo straight.
|
 dis106.jpg |
This is the other side of the trunk showing the undercoat line and marker bracket. Notice the thick texture of the undercoat. This can only be achieved by using a Schutz gun and spraying the undercoat through that. The stuff in the aerosol cans just does not get the right texture.
|
 dis107.jpg |
A good shot of where the door sticker goes.
|
Page: 1 2 3 4