 corner_widening2.jpg |
Filler section under construction. I started with a 3/4" wide strip of metal with each edge flanged to create a 3/8" filler.
|
 corner_widening3.jpg |
Filler strip tacked to half of corner piece. I then test fitted the part on the car to determine correct postion to tack weld other half of valence corner.
|
 corner_widening4.jpg |
Welding it back together after making initial tack welds on the car.
|
 corner_widening5.jpg |
Fully welded, before finish grinding
|
 corner_widening6.jpg |
Test fitting re-worked valence corner on car... WOO HOO, It Fits Correctly!!!!
|
 left_corner.jpg |
Corner before widening, note steel bar holding it at proper spacing
|
Page: 1 2